top of page

Ewoud M

Location: Netherlands

FDM / SLA 3D Printing


Ewoud has a Master's degree in Mechanical Engineering from the Technical University Delft. He then started his own 3D printing service company. This business has eight full-time colleagues and over 120 3D printers, and a lot of experience across many Additive Manufacturing use cases.

Ewoud can help you figure out what the possibilities are for implementing 3D printing in your company. He can advise about the chances where 3D scanning, 3D modeling, and 3D printing might be a good solution for your use case. He can discuss your own ideas and provide information about the possibilities of 3D printing, so you will know whether 3D printing can improve your manufacturing process or not.

Ewoud can help you find a viable use case, give you advice on what print technique or material is most suitable, help optimize your design for 3D printing or find you a suitable service provider.

Ewoud and his team have expertise in the following areas: 

  • Project Management & Business Case Preparation

  • Design & Simulation

  • Application Engineering

  • Process & Materials

  • Data Preparation

  • Machine Operation

  • Post-Processing

  • Measuring Quality

Book a session

If you want to know more about the booking process, please send an Email to our concierge here.

bottom of page